textWeb version
Application: Text Web version

You can set the following page parameters for your document:

Page Size: The size of document page for further printing.

Page Orientation: Choose between Portrait (vertical) or Landscape (horizontal).

Margins: Page margin sizes (modified by 0.1 inches (2.54 mm) with every click, select the mirror margins).

To open the page setup window, click File > Page setup and set the desired parameters. The parameters you set on this page will be applied to all pages of the document or to the selected section.

To change the page setup, do the following:

1.In the Page Setup window, select the Apply to drop-down list and select the option to apply the parameters to:

Whole document: Applies all subsequent changes to the selected part of the document separated from the other parts with the section breaks.

This section: Applies all subsequent changes to the whole document.

2.In the drop-down list Page Size, select the paper size to be used for printing.

3.In the Orientation section, select the desired page orientation: Portrait (vertical) or Landscape (horizontal).

4.Adjust the document margins as follows:

To set the same margins for all pages of the document, specify their width in the Top Margin, Bottom Margin, Left Margin, and Right Margin input boxes.

To customize the margins for double-sided printing of a document whose pages will be stapled together (for example, a brochure or book), select the Mirror margins check box. This active setting means that the margins on the left pages of the document will "mirror" the margins on the right pages of the document. In the Top Margin and Bottom Margin box, specify the width of the top and lower margins of the document. In the Inside Margin box, specify the width of the inner margins, which are the margins next to the binding. In the Outside Margin box, specify the width of the outer margins, which are the margins located at the outer edge of the book or brochure.

Mirror margins cannot be set for a part of the document and can only be set for the whole document. Therefore, this setting is active if you select Whole document from the Apply to drop-down list.

5.Click ОК.

Was this helpful?
Header and footer